Was anyone able to pass raw commands to a diseqc switch?
My setup is DP44 with a 110/119 twin pro lnb connected to port 1/2 respectively and a 129 single pro lnb going to port 3.
If I pass bypass the switch, I am getting signal from all of them. However, I do not get any signal through the switch.
I want to pass raw commands to dp44, but the DVBDream does NOT seems to pass them away. I use DEBUGVIEW and it CONFIRMS that NO commands are sent to the switch.
In DVBDream, my setup is:
Diseqc - none, all 3 satellites added under Port 1
RAW commands - This is where I input the commands
22 - off
Uncommitted port - Disabled
Note that if I set it up as a diseqc switch with sats on ports 1,2,3, I do see commands sent to the switch in DEBUGVIEW.
Anyone?
1.4i not passing raw diseqc commands
Moderators: Dreamer, FredB, X05
most probably, wrong format of diseqc command.
btw, you don't need raw commands with DPP44.
though, make sure that 18V is used for bandstacked LNBs (Preferences->General->Performance: it's set to 18V by default, unless you did some changes).
btw, you don't need raw commands with DPP44.
though, make sure that 18V is used for bandstacked LNBs (Preferences->General->Performance: it's set to 18V by default, unless you did some changes).
AMD x2 3800+, 2GB RAM, nVidia 6600GT (AGP)
latest BETA nVidia Audio/Video codecs (Cyberlink for H.264)
genpix 8PSK-to-USB2, Twinhan 1020
latest BETA nVidia Audio/Video codecs (Cyberlink for H.264)
genpix 8PSK-to-USB2, Twinhan 1020
Who is online
Users browsing this forum: No registered users and 1 guest