DvbDream Community

Hi.
I can not use DVBDream 1.4i because of this error:
"Incompatible codec or renderer combination is selected."

I tried to change Codec and Renderer to all possible values, but without success.

DVB Dream is using my Digital TV receiver, it is showing me signal, by blue led, after DVB Dream stars, but no picture is shown.
Obtained error is little bit general, is there some change to get detailed error info?

DVB Dream seems to be very good software, is a chance to get it run on 100%.
Thank you!

My system:

MSI digiVOX II ver.3, notebook Dell Precision 4300, nVidia Quadro 360m, 2GB RAM, 1.83 Intel Core2Duo, WinXP SP3

_________________
MSI digiVOX II ver.3, Dell Precision 4300, nVidia Quadro 360m, 2GB RAM, 1.83 Intel Core2Duo, WinXP SP3

It can not build a graph untill you tune a channel. Tune, then select codecs.

_________________
Twinhan 1020a driver 2.4.1.1, Skystar2 2.3 driver 4.4.0, Genpix USB, T90 and SG2100 w QPH-031.

You was right, Sorry for my post. It is possible to delete my post. I am happy, that you help me to get DVBDream working. Thank you!

_________________
MSI digiVOX II ver.3, Dell Precision 4300, nVidia Quadro 360m, 2GB RAM, 1.83 Intel Core2Duo, WinXP SP3

I have same probleme here..

_________________
SkYSTAR 2 PCI,DRIVER 4.4.1
DVBDREAM 1.4
WINDOWS XP

Try a couple of the audio codecs which have been reported to work well
Nvidia audio
Mainconcept
Microsoft Mpeg1

Verify the type of audio on that channel. Also ffdshow may be hijacking the graph, you could try to unregister it as a test.

_________________
Twinhan 1020a driver 2.4.1.1, Skystar2 2.3 driver 4.4.0, Genpix USB, T90 and SG2100 w QPH-031.