DvbDream Community

I have a Twinhan Card (1027) & Diseqc with 4 ports And I use Dvb Dream v.1.4i , it`s working well with Diseqc port No.1 only and the remaining Diseqc ports No.2,3,4 Not Working.(I mean the sat which connected with port No.1 is only Working And the sats which connected with ports No.2,3,4 arenot working ) .
Please Mr.Dreamer , There is a solution for that problem Or any Module solve it, sorry for elongation.

i don't think your post belongs to "bugs" section.

Bug Reports is a section to report application bugs (not user errors).

There are possible reasons of your problem:
1) you use a driver which does not support diseqc commands
2) your dish/coax-cables are not properly grounded (in 95% cases intermittent diseqc switching is due to lack of proper grounding)
3) you configured diseqc switch in DVB Dream incorrectly
4) your diseqc switch is dead

i don't think your post belongs to "bugs" section.

Bug Reports is a section to report application bugs (not user errors).

I so sorry for that .

There are possible reasons of your problem:
1) you use a driver which does not support diseqc commands

I use the least driver [ V1.0.2.9 (2009 09 29) ] from the company web site http://WWW.Twinhan.com , please if you have the suitable driver for the diseqc working , please upload it for me .

2) your dish/coax-cables are not properly grounded (in 95% cases intermittent diseqc switching is due to lack of proper grounding)

The diseqc work with the most of programs like ( Prog , Alt Dvb ,my theatre ) , so I think my dish/coax-cables are good .

3) you configured diseqc switch in DVB Dream incorrectly

here my pictures setting

4) your diseqc switch is dead

The diseqc work with the most of programs like ( Prog , Alt Dvb ,my theatre ) , so I think my diseqc is alive .