Page 1 of 1
DD 1.5c scan tps with nameless channels
Posted: Tue May 18, 2010 12:07 am
by patmos
When I do a full scan of any satellite,I get all nameless channels e.g Nameless 12682.
When I scan tp one by one (manual scan) then I get all channel names. Moreover , is there a way to prevent DD from saving my last scan? For example in the above I just want to discard scan result and keep the old one. How do I cancel?
Posted: Tue May 18, 2010 12:09 am
by vividweb
Getting the same issue. Tried increasing the scan delay numbers but did not help.
Using Genpix SkyWalker-1
Win server 2K3
EDIT:
Installed 1.4i and all works again. Something in my setup and 1.5c are not getting along.
Posted: Sun May 30, 2010 12:17 am
by jara88884
I also have this issue. I have skywalker 1&2 and technotrend dvb-s cards and they all give nameless scans with 1.5c version. I have tried auto and manual scanning with both types of cards with same results. I am a registered user with proper activation codes. I also run the 1.4e version and it scans correctly. I tried to update the channel name through channel properties but it comes back as nameless with 1.5c.
Posted: Mon Jun 07, 2010 9:14 pm
by vividweb
No follow up on this? Having talked to a few others it seems to be an issue with NA.
Posted: Mon Jun 07, 2010 10:04 pm
by reason
I noticed that it happens if you scan once while NA Fast Scan enabled. If you restart DD and never uses NA Fast Scan, the problem disappears.
Posted: Tue Jun 08, 2010 12:17 am
by rel
edited, *no need, fixed*
Posted: Tue Jun 08, 2010 3:14 am
by reason
It happens on all transponders on NileSat.
Posted: Tue Jun 08, 2010 3:19 am
by rel
It happens on all transponders on NileSat.
Why do you enable NA (North America) for NileSat ??! (it is middle eastern satellite)
ofcourse you will have problem with wrong settings
Posted: Tue Jun 08, 2010 3:26 am
by rel