1.5c disecqc problem on start up

[hypermood]

I have three sats on a diseqc.
1) Hotbird 13.0
2) Astra 19.2
3) Astra 28.2
I have to tune to to a hotbird channel before I can tune to the Astra channels. If DD starts on an Astra channel then there will be no signal until I tune to a hotbird channel and then go back to the Astra channel. This is a nuisance in timed recordings and I'm using a workround of setting a timer recording of just one minute from a hotbird channel before setting the timer to the channel I want to record. I then set a further recording of a minute to a hotbird channel so that DD closes on a tunable channel.

[Dreamer]

Have you tried Scanman's device? It works good with SS HD2.

[Yany]

Diseqc problems here also. Skystar HD2.

- "Go to" not working correctly, moves antenna few degrees off, works just few times, than stops
- "drive" works few times, than stops and I have to restart PC

Tried Scanmans 1.06, 1.08, 1.1.1, first doesn´t work, second crashes while scanning, last one hangs DD on startup, if not, crashes on channel changing.

[rel]

please test with v1.5e or above