Once you install winlirc_setup.exe to your DD installation folder, make sure you have it configured right and set to the correct COM1 or COM2. Set your remote profile to Skystar_2 in the dropdown. Then push the button to test it. You should see that icon turn green each time you push a button. Load ...

Use the scheduler to schedule recordings. It's kinda weird but the easiest way I've found is select the channel you want from the left hand side before going into the scheduler to schedule it because you don't get a channel # when you go into the scheduler itself. Unless there's some setting I misse...

I still wish DVBEPG to be able to schedule recordings. Only watch and record now works. :( Installed 1.4G on top of F, all good. Been running for about 10 hours, plugins and modules as I see fit, running DVBEPG, my choice of codecs, no jitter, no losses, a few resets, smooth as glass. Favorite audio...

1.4f gives me dvbepg ini might cause problems and just hangs. When I finally cleared out the INI I can't scan anything so I just reinstalled 1.4d and it works just fine. So is DVBEPG not working at all with 1.4f?

How do you switch channels using the remote other than using the up and down arrows? I tried punching in the channel number but it does nothing. Any ideas?

Thanks.

I did the above things and I encounter the other problem I am having. Just for reference, I have the device as the twinhan direct device. I set the lnb to na legacy at 11250000. I go to manual scan and scan 12239 Mhz on echo 7. I get 67% signal and 98% quality. However, the scan will detect no chan...

I can't even get VMR9 to work at all. I just use the VMR and it works fine. I tried all the possible combos to get VMR9 going and no luck. FDSHOW was the same. By the way is it better to lower the resolution when plugged into a HDTV using a DVI-HDMI cable? The quality of the video isn't so great but...

Open up notepad and add the lines to start the programs. Example: For DD you would put in the file the line below. c:\dvbdrem\dvbdream.exe Then save it as "dvbdream.bat" and change the file type to all types. So to start winlirc first you would go find the exe for winlirc and add it above the line a...