HH motor and a Skystar2

[StoneTower]

I just got a Geosatpro GS-120. I have been told that is is the same as the SG-1200. It moves just fine in MyTheater so I know that the cable and the Motor work. (MT has very limited motor control). I very much like Dvbdream (there is nothing better ) But I am having problems getting a driver that will work and move the motor. If someone could tell me what works and where to get the drivers it would be great.

On a side note. I have a DP500 that I just got working. Could I use a Diseqc switch right after the PCI card and switch between the cable with the DP500 and the 36" dish with the rotor? If this will not work, can an A/B switch be used without cooking something (Which one would be best to pass the Sat signal)?

[rel]

use Mibi's patched drivers for SS2 (it will enable raw diseqc to command the motor)

[StoneTower]

What is the latest version and where can I get it?

Thanks

[oMikR0n]

Its all there: http://www.dvbskystar.com/motordiseqc.html