How do I hook these dishes up....

[mrnewbie]

I know there are similar threads on this subject..but I just couldn't find a definative solution..so I'm asking..

How do I hook it all up..
The problem...I have 2 sub boxes running off the dish 1000.2..It just so happens this dish has 3 outputs...

So how do I hook up the 3rd output of 110,119,129 and the other dish 82,91 all to one Skywalker-1...I'm under the impression..I can't plug that 3rd output into the Diseqc..so I need to combine the diseqc and the 3rd output of the 1000.2dish...HOW?


1st dish: Old Legacy Dish 500 to Diseqc ports 1 & 2 aimed at 82 & 91
2nd dish: DISH 1000.2 aimed at 110,119,129

At this point in time, I'm swapping cables.
I can swap cables and get all the channels from each dish.



Video : InterVideo V8.0.6.109 3/20/2007
Audio : InterVideo V8.0.6.109 3/20/2007
VR: VMR9
CoreAVC 1.6.0
Genpix Skywalker-1
KFA GeForce 8600GT 1G mem
Intel Pentium D 3.4GHZ
2GB DDR2-667

[zag1958]

Try using a 22Khz switch.

[mrnewbie]

I'm not sure how all this would work...But I'm willing to try

Is this what you are suggesting...

[beagle]

I think it would be more like port 4 22khz on=91 and port 4 22khz off=82.
I'm not sure if it will work but try both infront of the 1000.2's built in diseqc switch or behind in the cable order.

[zag1958]

I'm not sure how all this would work...But I'm willing to try

Is this what you are suggesting...

I was thinking more along the lines of what mrnewbie said but I don't see why what you sketched wouldn't work.