Cannot use a 8/1 Diseq..

[Professore]

Hello to everyone. I have the Technotrend s2-3200 sat card. I am trying to manage to work over 4 satellites with dd, but i didnt. I have tried a lot of different bda drives. I have read sth about raw commands for the diseqc, but i dont know where to put them.. Can anyone help me? The diseqc that i have is the following..

[genpix]

looks like it's standard UNcommitted diseqc switch.
Just select "None" as a diseqc switch, and add all sats.
Configure proper LNB for each sat, enable uncommitted switch and select proper input (last tab).

this is of cause, assuming that your driver can understand diseqc commands.

[Professore]

thank you for your answer. You mean the BDA driver? i have the default from DD. I am not also sure about the LNB type. I have let them to: KU Linear (Universal). The sattelite that i use are: Astra1, Hotbird, Astra2, Hellasat, Turksat, Badr3.. in "Raw Diseqc" tab i dont put nothing? Finally, the Uncommited Switch Port count begins from 0 in DD, but at my diseqc from 1. Shall i use 0 for the port1?
thanks once more..

it seems like when i changed to the BDA_aLL 1.1 the sattelite that is at port2 of the diseqc is working fine. Then i tried to use the latest bda_s driver and the sattelite that i have at port1 is working.. Now whatever driver i use only the sattelite at port 1 is working.. and that not with the 1st click on a channel, but with the second..

[gertschi]

I have same card and same switch, also I had same probs like you until now.
Today I tried the new WDM-deviceinterface from BxS, it works perfectly using the uncommited-feature settings combined with raw-DiseqC v1.1 commands!

e.g.
Lnb1: raw command E0 10 39 F0, uncommittet port 0
Lnb2: raw command E0 10 39 F1, uncommittet port 1
and so on