DvbDream Community

Hello,

I need the advice from the experts here. I swear I have tried practically everything, read through the forum, and ready to give up.

I have a Twinhan Visionplus 1030 with Dish 500 Dual Legacy LNB

http://www.cf2a.com/catalog/images/dish500.jpg

I have tried both a 22khz switch and a Pansat 4x1 diseqc 2.0

I cannot get the card to switch over to the second port for the life of me.

I have tried every lof setting I can think of but I'll name some I've tried.

22khz tried:

Lof-1 and 2 - 11250000 Lof-SW 12700000
Lof-1 and 2 - 11300000 Lof-SW 12700000 (pick up first transponder correctly but everything else is either no signal or channels from port A)

Pansat 4x1:

Lof-1 and 2 - 11250000 (tried port 2, 3, 4, plus MiniDiseqc, Same channel found as Port 1)

I have tried both the BDA drivers and WDM drivers, running TwinHan direct found as well.

If i connect directly to each LNB, it finds the channel fine. I am trying to pick up echostar 7 and echostar 8

Any suggestion will be appreciated.

For the 22K try Switch Settings;
11700 = tone on
12700 = tone off

On - Works in receiving full channel
Off - No Signal

That's pretty much been my experience.

Connect directly and scan, no switch.

If then you can only switch to one satellite with those SW settings 11700/12700, it means your 22K switch is not working.