DvbDream Community

Hi,
I'm using an old direct tv dish and standard lnb, I have it pointed at 119, and know that there is a signal there because I found the satellite by connecting it to a reciever.
I've tried all typs of lnb settings but none work.
I know that everything is working in DD because I was able to watch BEV 1 and 2. But for the life of me I can't seem to get 119 to work.
I'm not using any Diseqc settings (set on NONE)
Any answers out there.

do you use the same LOF as you did for other sats?

Yes I used the default lof settings.

Yes I used the default lof settings.

with this amount of information you provide you'll receive zero help.

default settings for WHAT?!

if you are not using a diseqc switch, LNB type might be misconfigured, Make sure you have selected the right LNB Type and LOFs if you are using a non-standard LNB. You must make sure of that you are trying to tune on a DVB-S (QPSK) transponder. If modulation is different than this, your SS2 wont be able to see any signal level.

if you are using a diseqc switch, you will need Mibi's patched WDM drivers for SS2 to perform better with diseqc and switches on DVB Dream. (use B2C2-Direct device.)