DD error code I cannot overcome
Posted: Wed Nov 28, 2007 9:10 am
Was an MT user. (sucked to much CPU)
Decided to try DD. Downloaded 1.4d.
After reading and experimenting was able to configure.
Ended up with NVIDIA Pure for video and audio.
Overlay renderer.
Realtec97 audio
Only 1 sat 82W.
Changed LNB setting to circular, LOF 11250000
Diseqc none and Nimiq2
One of the 2 3rd party plugins.
Left all other settings to default.
Updated 2780 ini file in DD program
Rebooted PC.
Started DD, got great Q&S, both plus 90%.
Scanned #1 TP (12224) ONLY.
Scan picked up only 3 channels neither of them on 12224 according to Lyngsat, but all showed great picture, but best of all low CPU usage.
Run for 5-10 minutes then crashed.
I tried to exit got an error window pertaining to Msdvbnp.ax and other windows that were all greek to me.
After 3 trys had to use ctrl-alt-del to end program.
Tried an uninstall-re-install of 1.4d, no signal same error when trying to close. Uninstalled 1.4d tried 1.3c, no signal, tried to close, got the same
error again. Check of all logs showed warnings and failed processes.
Opened MT all still running fine.
After a lot of reading, could not find any info to lead me down the right path. As far as I know I did a thorough clean out of all DD files from my
system before doing a fresh install but error just keeps coming back.
Can someone help me here please.?
Thanks
Further checking leads me to believe I may have a directx problem.
I just recently upgraded to dx10 with the understanding it will not
interfere with dx9 compatible cards.( something about backward capabilities). I'm not so sure this is exactly correct
for Twinhan
Decided to try DD. Downloaded 1.4d.
After reading and experimenting was able to configure.
Ended up with NVIDIA Pure for video and audio.
Overlay renderer.
Realtec97 audio
Only 1 sat 82W.
Changed LNB setting to circular, LOF 11250000
Diseqc none and Nimiq2
One of the 2 3rd party plugins.
Left all other settings to default.
Updated 2780 ini file in DD program
Rebooted PC.
Started DD, got great Q&S, both plus 90%.
Scanned #1 TP (12224) ONLY.
Scan picked up only 3 channels neither of them on 12224 according to Lyngsat, but all showed great picture, but best of all low CPU usage.
Run for 5-10 minutes then crashed.
I tried to exit got an error window pertaining to Msdvbnp.ax and other windows that were all greek to me.
After 3 trys had to use ctrl-alt-del to end program.
Tried an uninstall-re-install of 1.4d, no signal same error when trying to close. Uninstalled 1.4d tried 1.3c, no signal, tried to close, got the same
error again. Check of all logs showed warnings and failed processes.
Opened MT all still running fine.
After a lot of reading, could not find any info to lead me down the right path. As far as I know I did a thorough clean out of all DD files from my
system before doing a fresh install but error just keeps coming back.
Can someone help me here please.?
Thanks
Further checking leads me to believe I may have a directx problem.
I just recently upgraded to dx10 with the understanding it will not
interfere with dx9 compatible cards.( something about backward capabilities). I'm not so sure this is exactly correct
for Twinhan