DvbDream Community

I just got a Geosatpro GS-120. I have been told that is is the same as the SG-1200. It moves just fine in MyTheater so I know that the cable and the Motor work. (MT has very limited motor control). I very much like Dvbdream (there is nothing better ) But I am having problems getting a driver that will work and move the motor. If someone could tell me what works and where to get the drivers it would be great.

On a side note. I have a DP500 that I just got working. Could I use a Diseqc switch right after the PCI card and switch between the cable with the DP500 and the 36" dish with the rotor? If this will not work, can an A/B switch be used without cooking something (Which one would be best to pass the Sat signal)?

use Mibi's patched drivers for SS2 (it will enable raw diseqc to command the motor)

What is the latest version and where can I get it?

Thanks

Its all there: http://www.dvbskystar.com/motordiseqc.html