Page 1 of 1
dd 1.4i crashes on empty tp
Posted: Mon Mar 10, 2008 6:03 pm
by dfwpilot
I installed latest version of dd and when I scan - it crashes on emty tps. When I scan tp separetly it scan the tp, shows the channels and even on manual scan when i hit empty tp it crashes also.What can be wrong? What I'm missing? Twinhan 1027 p4 3.6ghz.
Posted: Mon Nov 10, 2008 6:05 pm
by Outback199
I have the exact same problem. Have you had any success with this yet?
I can get it to work with MT.
Posted: Mon Nov 10, 2008 7:03 pm
by genpix
what is "empty tp"?
Posted: Wed Nov 12, 2008 8:07 am
by Outback199
Well, I meant it as empty transponder - no channels found on it.
In MT I can scan 110 and 119. But there are about 5 TP's it cannot lock.
I've got Dream to a state where I can scan, but when it hits the first of those 5 TP's, it crashes, and the process stays resident, usually a reboot is needed.
I've tried the BDA_ALL (scanman's ?) driver with no success as well as the modified transponder list .ini's which remove all the vertical TP's.
What puzzles me is I was using Dream perfectly with Bev on 91 only. Scanned easily. If I remove the switch and attempt to scan 119 alone, I get the crash.
What's the difference in 119 and 91's TP list??
Posted: Wed Nov 12, 2008 9:12 am
by genpix
do you know what spot-beam is?
you are not talking about spot-beams, are you?
Posted: Wed Nov 12, 2008 9:29 am
by Outback199
No sorry - I do not.
Although I just wiki'd... now I have an understanding of what that is, I can say - I'm not doing that!
