Page 1 of 1
Twinhan 1027 Diseqc functions
Posted: Sun Mar 16, 2008 4:08 pm
by slappy
Still no support for the Twinhan 1027 diseqc protocol in DvbDream?
Someones found anything new ?
All the previous forums as not fixed the problems.
Posted: Fri Mar 21, 2008 8:19 am
by CausticSoda
Wondering the same thing myself. A lot of people use the 1027. I have resorted to using an STB to do the diseqc switching.
Posted: Mon Mar 24, 2008 7:47 am
by genericdude
Hey CausticSoda, How did you get your STB to switch diseqc for you? Did you just connect your diseqc to your STB and connect the Twinhan to the LOOP OUT connection on the STB?
If so, how do you make the STB simply a switching slave? I would think if you have your STB on a specific channel, then the Twinhan would only be able to see stuff on the same transponder until you manually change the channel on your STB then switch back to your Twinhan. It would kinda suck to have to flip back and forth like that for every channel change.
Posted: Tue Mar 25, 2008 2:52 am
by CausticSoda
Yes, that is pretty much how I did it. You tune the STB on whatever sat you want and that will be the one that gets passed out the LOOP OUT connector. Since I'm using dishpro, I don't have to worry about polarity.