DvbDream Community

Was anyone able to pass raw commands to a diseqc switch?

My setup is DP44 with a 110/119 twin pro lnb connected to port 1/2 respectively and a 129 single pro lnb going to port 3.

If I pass bypass the switch, I am getting signal from all of them. However, I do not get any signal through the switch.

I want to pass raw commands to dp44, but the DVBDream does NOT seems to pass them away. I use DEBUGVIEW and it CONFIRMS that NO commands are sent to the switch.

In DVBDream, my setup is:
Diseqc - none, all 3 satellites added under Port 1
RAW commands - This is where I input the commands
22 - off
Uncommitted port - Disabled

Note that if I set it up as a diseqc switch with sats on ports 1,2,3, I do see commands sent to the switch in DEBUGVIEW.

Anyone?

most probably, wrong format of diseqc command.

btw, you don't need raw commands with DPP44.
though, make sure that 18V is used for bandstacked LNBs (Preferences->General->Performance: it's set to 18V by default, unless you did some changes).