Switching off LNB Power
Posted: Sun Nov 16, 2008 11:35 am
Hi
Am a newbie to this stuff.
Have just installed DVBDream on XP Workstation.
I want to know how i turn off the power to the LNB.
Reason: I installed the DVB card (Twinham 1020A) and installed the software that came with it. I also have a Fortec box running at the same time through a splitter. When I run DVBDream the signal on my Fortec box vanishes. On the Twinhan software, once I switched off the LNB power this problem went away.
I have 2 fixed dishes pointing to DN and BEV.
Following this, are there any standard settings I should use to get these two dishes to run?
Cheers
Traveller
Am a newbie to this stuff.
Have just installed DVBDream on XP Workstation.
I want to know how i turn off the power to the LNB.
Reason: I installed the DVB card (Twinham 1020A) and installed the software that came with it. I also have a Fortec box running at the same time through a splitter. When I run DVBDream the signal on my Fortec box vanishes. On the Twinhan software, once I switched off the LNB power this problem went away.
I have 2 fixed dishes pointing to DN and BEV.
Following this, are there any standard settings I should use to get these two dishes to run?
Cheers
Traveller