Page 1 of 1

Using a DVB-S and DVB-T card at the sane time?

Posted: Sat Oct 22, 2011 4:26 am
by solus
Hello from a new user.

I an trying to get DVB Dream v1.5g to work with my two installed cards. One card is a Compro Videomate S350 for satellite and the other is a Winfast DTV1000s for terrestial DVB-T.

Both cards work fine with DVB Dream when installed in the machine sepatately. When I install both cards, the drivers are fine and there is n IRQ conflict. However I am sure that both cards are trying to use the BDA device interface.

Is it possible to use this combination? I am running into trouble because I am also running a DISCEQ switch to swap between two lnb's on the same dish.

I fear it may not be possible to do this as both devices are competing for the same device driver?

Many thanks,

Sol.

Posted: Thu Oct 27, 2011 1:32 pm
by Dreamer
It should work good, at least in the latest version.

Install DD twice, into 2 different folders and setup both separately, then both should work good at the same time.

http://www.dvbdream.org/forum/viewtopic ... 1715#11715

This is the latest version changelog:

- Device dialog now lists the devices of the same interface

Posted: Sat Nov 05, 2011 1:15 am
by Snuffer
i have running this setup with a TBS twin tuner card.
Do not forget to set A en B in DD if not you have problems.