Page 1 of 1
Dvbdream 1.6, terratec cinergy s2, HD channels and diseqc
Posted: Thu Nov 17, 2011 4:48 am
by mix74
Does new version of DVBDream support the Terratec Cinergy S2 without problems on HD channels and support diseqc whit this card?
Thanks
Re: Dvbdream 1.6, terratec cinergy s2, HD channels and diseq
Posted: Thu Nov 17, 2011 6:11 am
by rel
that is for you to test
test v1.7 please, today released.
In this version, if diseqc doesn't work, try changing diseqc method under device options (in options menu)
Please report here after testing
Re: Dvbdream 1.6, terratec cinergy s2, HD channels and diseq
Posted: Thu Nov 17, 2011 9:46 am
by mix74
Ty...i will try
Re: Dvbdream 1.6, terratec cinergy s2, HD channels and diseq
Posted: Thu Nov 17, 2011 2:00 pm
by mix74
Ok...just tried 1.7 version
HD Channels ok
Very very slowly change channel
Diseqc work but very slow and sometimes crash
I tried to use mantis bda driver from rOOt and all is ok (only diseqc dont work good)
Re: Dvbdream 1.6, terratec cinergy s2, HD channels and diseq
Posted: Thu Nov 17, 2011 2:19 pm
by rel
Ok...just tried 1.7 version
HD Channels ok
Very very slowly change channel
Diseqc work but very slow and sometimes crash
these are with DD's own BDA interface (bda.dev) or with rOOt's interface ?
if DD's, did you change any setting or it worked as is, with defaults ?
using latest terratec drivers ?
Re: Dvbdream 1.6, terratec cinergy s2, HD channels and diseq
Posted: Fri Nov 18, 2011 3:59 am
by mix74
these are with DD's own BDA interface (bda.dev) or with rOOt's interface ?
if DD's, did you change any setting or it worked as is, with defaults ?
using latest terratec drivers ?
This is with bda.dev
I tried with all settings in the panel.
My driver: 1.01.01.901 (it's not the last)
I will try with the last driver later
Re: Dvbdream 1.6, terratec cinergy s2, HD channels and diseq
Posted: Sun Nov 20, 2011 1:59 pm
by mix74
I tried lasted driver... it works better but very very slow...never crash but lost the signal often