DirectShow Error#
Posted: Mon Jan 21, 2013 2:04 pm
Hi,
I'm new to DVB Dream and I'm currently attempting to install the trial software and have encountered a number of errors, which has stopped progress.
I'm running an OS of Win 7 (64 bit), with two cards TBS PCI-E DVB-T2 6280 & TBS PCI-E DVB-S2 6981.
I am getting the following error on start-up "DirectShow Error# can not create audio renderer". I read all the cautions displayed on the page about using nVidia or Sonic codecs for video and Intervideo for audio, which may need to be manually inserted into "codecs.ini".
I have no idea what it's going on about! Starting from the basics, where can I find these suggested codecs and when I've got them, where do I put them?
Whilst it's fairly obvious that this is the initial problem which is stopping the job, I have a number of other issues which I could do with help over:-
I wasn't getting any video but at the moment I can't test if I've fixed that (info came from here) due to the above problem.
How do I tell the software that there is a second card and get it to scan that card too?
And on the satellite card, how can I tell it that there's only one of the two LNBs in use?
I'm new to DVB Dream and I'm currently attempting to install the trial software and have encountered a number of errors, which has stopped progress.
I'm running an OS of Win 7 (64 bit), with two cards TBS PCI-E DVB-T2 6280 & TBS PCI-E DVB-S2 6981.
I am getting the following error on start-up "DirectShow Error# can not create audio renderer". I read all the cautions displayed on the page about using nVidia or Sonic codecs for video and Intervideo for audio, which may need to be manually inserted into "codecs.ini".
I have no idea what it's going on about! Starting from the basics, where can I find these suggested codecs and when I've got them, where do I put them?
Whilst it's fairly obvious that this is the initial problem which is stopping the job, I have a number of other issues which I could do with help over:-
I wasn't getting any video but at the moment I can't test if I've fixed that (info came from here) due to the above problem.
How do I tell the software that there is a second card and get it to scan that card too?
And on the satellite card, how can I tell it that there's only one of the two LNBs in use?