DvbDream Community

WindowsXP 32 bit - TBS QBox-S2 USB - momoblock Mascom 19.2E and 23.5E.
DVBDream 2.9.3.4 TBS OEM, settings diseq-C 19.2E port 1, 23.5E port2, switch function of satellites and receiving OK.
Windows7 64 bit - the same settings accept only 19.2E does not switch on 23.5E. Drivers for TBS QBox S2 and Windows7 64bit, version 2.0.4.2.
Please advise where is the error?

Can you zip and send your \logs folder from dvbdream ? (c:\dvbdream\logs)
From Windows 7

Thanks for the response. I am sending the requested logs.
TBS Q Box S2 USB
QBOXS2 vhid 1.0.3.0
S2QBOX 2.0.4.2
DVBDream 2.9.3.4.TBS OEM
bda.dev 63448 b
Windows 7 Pro 64 bit, TBS drivers from the installation CD for windows 64 bit
With the best regards Primo

Everything looks alright at DD side.
In bdaext.log ( that is the last point where diseqc commands are processed and sent to driver from DVB Dream), I can see correct diseqc commands.

Try to update / reinstall TBS drivers. (if already up-to-date, switch back to an older driver if you can find)

This device is probably old now, I'm not sure if TBS still works on drivers,
Old WDM drivers might be working fine (for Windows XP etc) but newer BDA drivers (for Windows 7 and upwards) might not be working well with diseqc.

Thanks for the answer.
Drivers from the pages of TBS, I tried with the same result.
I understand your observations. DD creates the right RAW commands
but you don't get to the switch or the motor.
It's an older device, but if the TBS will issue Windows 7 64 bit drivers for,
then you should be working on 100% including Diseq-C.
Because DD is in conjunction with the engineers of the TBS, please for help in solving
This problem. Other features DD are excellent and it is a pity that you cannot use the
switch or the motor.
Sincerely Primo