Positioner How-To?

[snoop244]

I've got my SG2100 working under MT, but I can't get it to move the dish in normal use under DVBDream. In the positioner console I can use the east/west control to move the motor, but go-to-x and usals doesn't seem to work. The dish doesn't move at all. Is there a good description of how to set up a positioner?

I'm using the Twinhan SDK. I am setup for Diseqc 1&2, with each satellite under the first port. Is this correct? I have even tried copying the raw diseqc commands from the positioner into the raw diseqc box on the satellite's diseqc setup. No luck.

Does anyone have a positioner working? From reading all the posts I can't really tell. It is listed as a feature, but I'm wondering if it is incomplete.

[starman]

I have the same problem as the poster above, very similar setup, has anyone figured out how to get USALS working?