DvbDream Community

I have 4 LNBFs on my 4x1 DISEq and am trying to add a 22 kHz tone switch between one port of the 4x1 in order to run and two LNBFs of this leg.
I adjusted the DISEq set-up in Dream, but cannot access the LNB which requires the 22kHz.
I think that my Twinhan card might not do the switching. Has anypne experience running more than 4 LNBFs in their system?
I have a 70 ft coax run to my dish.
Thanks in advance for a reply.

I have 4 LNBFs on my 4x1 DISEq and am trying to add a 22 kHz tone switch between one port of the 4x1 in order to run and two LNBFs of this leg.
I adjusted the DISEq set-up in Dream, but cannot access the LNB which requires the 22kHz.
I think that my Twinhan card might not do the switching. Has anypne experience running more than 4 LNBFs in their system?
I have a 70 ft coax run to my dish.
Thanks in advance for a reply.

Set "LOF-SW" to 11700000 for the 22KHZ port of the Tone switch, and set "LOF-SW" to 12700000 for the 0 (no tone) port of the Tone switch. Under 22KHZ tab select "control by LOF-SW".

trying to figure out how to set up my 22khz switch can i get some help please. i am lost