DP 500 Config with Twinhan
Posted: Sun Apr 15, 2007 1:22 pm
It appears that while using Twinhan BDA drivers there is no way to receive high-definition channels which are broadcast using Turbo-FEC 8SPK. Is there any workaround for this -- using Twinhan direct drivers, etc? I heard that MyTheater may do it -- is that because of the direct drivers?
Next question, it also seems as though the Diseq switch issue is completely ignored by the drivers. I receive duplicate channels when scanning birds 110 and 119. I know that the channels are officially only carried by one satellite or the other. Is there a way to separate these two satellites properly by using the 22 kHz tone configuration? I know the DP 500 operates more like it is not on a switch but it is multiplexed using the 22 kHz tone. Can I manually change the frequencies of a particular transponder by adding 22,000? I haven't been able to figure that out. Could this also be something that is ignored by the BDA drivers?
A related issue seems to be that I cannot find certain channels. A good example is trying to add FSTV from bird 110. I have the proper frequency for the transponder and parameters and it does not find it. It does find some channels that are not supposed to be on that transponder so I suspect that my problem has something to do with the 22 kHz tone multiplexing thing.
I have spent a lot of time researching this on these boards and others. I would only ask for help after putting in my due diligence. Any direction appreciated. Thank you.
Next question, it also seems as though the Diseq switch issue is completely ignored by the drivers. I receive duplicate channels when scanning birds 110 and 119. I know that the channels are officially only carried by one satellite or the other. Is there a way to separate these two satellites properly by using the 22 kHz tone configuration? I know the DP 500 operates more like it is not on a switch but it is multiplexed using the 22 kHz tone. Can I manually change the frequencies of a particular transponder by adding 22,000? I haven't been able to figure that out. Could this also be something that is ignored by the BDA drivers?
A related issue seems to be that I cannot find certain channels. A good example is trying to add FSTV from bird 110. I have the proper frequency for the transponder and parameters and it does not find it. It does find some channels that are not supposed to be on that transponder so I suspect that my problem has something to do with the 22 kHz tone multiplexing thing.
I have spent a lot of time researching this on these boards and others. I would only ask for help after putting in my due diligence. Any direction appreciated. Thank you.