Positioner not always responding when changing satellites

[dmyers6]

My Satellite Positioner does not always change position when I select a channel on another satellite. I have "Auto-Drive on Start-Up" and "Auto-Drive on Channel Change" selected.

It always changes to the correct satellite on start-up if I shut it down, but after about 2 or 3 more times of changing positions, it stops working.

If I select "Confirm Motor Driving," it will work, but I have to confirm everytime I change satellites.

I have the Positioner Type set to "Generic Diseqc."

Maybe it needs some sort of delay after changing the channel and selecting the correct LNB port on the DiSEqC Switch, and before it sends the DiSEqC command to the Dish Positioner.