DvbDream Community

Hi

(Sorry starting new thread but this is a new problem)

Im using a prof 7300, moteck 2100 motor. Bda Driver 2.4 and dvb dream 1.4i.

I can't seem to get the motor to move. My positions are stored in the motors memory the way I want them from my dreambox.

But I can't get dvbdream to drive the motor to a stored position.

I select the stored position in the position menu and press "go-to" but the motor does nothing, i even tried the raw diseqc command+send. But nothing.

I relise from reading the forum that some cards are having teething problems with diseqc, is the prof the same, or has anyone successfully gotton it to work with positioner.

Thanks Guys for all your help.

hi man,

I have 7301 PCI. If you are using 1.4i you have to copy a bda_prof.dev to the devices folder. You can get in on the prof website
Module (PTG Engine) DVBDream (Prof-6200/7300/7301/7500)
http://prof-tuners.com/download/soft_pr ... a_prof.dev

Later on you have to select in the devices list, the prof bda 1.4 PTG engine/ instead of original, BDA 2.1.0.

1.5a works fine with the original bda file, and you do not need to copy this file. I have fought with this shit whole day before I have found out it.

BTW there is a problem with the USALS calculation, if you are using stored position then it does not matter.