DvbDream Community

When I do a full scan of any satellite,I get all nameless channels e.g Nameless 12682.
When I scan tp one by one (manual scan) then I get all channel names. Moreover , is there a way to prevent DD from saving my last scan? For example in the above I just want to discard scan result and keep the old one. How do I cancel?

Getting the same issue. Tried increasing the scan delay numbers but did not help.

Using Genpix SkyWalker-1
Win server 2K3


EDIT:
Installed 1.4i and all works again. Something in my setup and 1.5c are not getting along.

I also have this issue. I have skywalker 1&2 and technotrend dvb-s cards and they all give nameless scans with 1.5c version. I have tried auto and manual scanning with both types of cards with same results. I am a registered user with proper activation codes. I also run the 1.4e version and it scans correctly. I tried to update the channel name through channel properties but it comes back as nameless with 1.5c.

No follow up on this? Having talked to a few others it seems to be an issue with NA.

I noticed that it happens if you scan once while NA Fast Scan enabled. If you restart DD and never uses NA Fast Scan, the problem disappears.

edited, *no need, fixed*

It happens on all transponders on NileSat.

It happens on all transponders on NileSat.

Why do you enable NA (North America) for NileSat ??! (it is middle eastern satellite)
ofcourse you will have problem with wrong settings

Fixed,
patch here for the problem, please test.
http://www.dvbdream.org/forum/viewtopic ... highlight=