Do not tune last channel after manual scan
Posted: Fri Jun 17, 2011 9:14 am
Hi,
Detailed description:
When some channel is active and then manual scan is used, after confirming dialog with list of new programs it tunes back the old channel.
This is very annoying when doing feedhunting on low SR, where it takes 20-30 sec to tune some channels.
Best would be to just leave card tuned to current frequency with just scanned signal, or tune 1st program that was just scanned (and select it in program tree/list).
This needs to be done only when doing single channel manual scan, for transponder list scanning it's OK as it is, tuning back original channel.
r00t
Detailed description:
When some channel is active and then manual scan is used, after confirming dialog with list of new programs it tunes back the old channel.
This is very annoying when doing feedhunting on low SR, where it takes 20-30 sec to tune some channels.
Best would be to just leave card tuned to current frequency with just scanned signal, or tune 1st program that was just scanned (and select it in program tree/list).
This needs to be done only when doing single channel manual scan, for transponder list scanning it's OK as it is, tuning back original channel.
r00t