DvbDream Community

If you start recording a video often it is named by the event name of the event before, because the event name switched a few seconds or minutes to late to the correct name.

My idea to solve this problem:
DVD Dream 'knows' the event name 'now' , the next event name and the time until the next event begins (these infos are displayed on OSD).

Why not automatically using the next event's name if the time until the next event begins is below a specified value (let's say 2 or 3 minutes)?

(I hope anybody understood what I wrote, my english is not the best... )

Today I realized that the displayed event name will not be refreshed...

When you start a recording the displayed eventname stays the same until the end of recording.
Unfortunately the displayed event name at the beginning of a recording mostly is the eventname of the event before.

This issue has already been notified, DD does not refresh this information till you make a channel switch.