1.2 - Diseqc switch problems

Dreamer · Postby **Dreamer** » Sun Sep 03, 2006 2:07 pm

Several users in Czech/Slovak Skystar 2 forum reported problems with diseqc switch - scanning, there is a signal on few TPs only. I don't have a diseqc switch, so I can't test it. They said it was OK in previous version.

Please test it if you can...

scaistar · Postby **scaistar** » Sun Sep 03, 2006 3:37 pm

hereon my forum too. Ok with Hotbird but some 5 transponder on Astra
I have motor.. so cannot test

Depend from new compatibility driver?

onix · Postby **onix** » Tue Sep 05, 2006 12:35 am

New version is not work with Vertical polarity TP.Only horizontal polarity.
I use Skystar 2(rev2,6d,version driver is4.28.999) and Eurosat diseq ,HotBird and ExpressAM22.

atomu235 · Postby **atomu235** » Tue Sep 05, 2006 8:37 am

Diseqc doesn't work on my config

(both vertical and horizontal - tried about 10 of each and nothing...)

edit
1.2a solved the problem

THANKS

-----------------------
Skystar 2.6D, driver 4.3.2, DiSEqC 2/1 S.162 - G VIPER and two Golden Interstar GI-201 LNBs (HB 130 and Astra 192).
Codecs: Cyberlink(new) + Intervideo.
Hardware: Athlon TB, AbitNF7, GF6600, SB Audigy.
OS: WinXP

Dreamer · Postby **Dreamer** » Fri Sep 15, 2006 5:32 pm

edit
1.2a solved the problem THANKS

Thanks for information, please start a new post if you report such important informaion next time.

Closed.

1.2 - Diseqc switch problems

Who is online