1.2 - Diseqc switch problems

[Dreamer]

Several users in Czech/Slovak Skystar 2 forum reported problems with diseqc switch - scanning, there is a signal on few TPs only. I don't have a diseqc switch, so I can't test it. They said it was OK in previous version.

Please test it if you can...

[scaistar]

hereon my forum too. Ok with Hotbird but some 5 transponder on Astra
I have motor.. so cannot test

Depend from new compatibility driver?

[onix]

New version is not work with Vertical polarity TP.Only horizontal polarity.
I use Skystar 2(rev2,6d,version driver is4.28.999) and Eurosat diseq ,HotBird and ExpressAM22.

[atomu235]

Diseqc doesn't work on my config (both vertical and horizontal - tried about 10 of each and nothing...)

edit
1.2a solved the problem THANKS


-----------------------
Skystar 2.6D, driver 4.3.2, DiSEqC 2/1 S.162 - G VIPER and two Golden Interstar GI-201 LNBs (HB 130 and Astra 192).
Codecs: Cyberlink(new) + Intervideo.
Hardware: Athlon TB, AbitNF7, GF6600, SB Audigy.
OS: WinXP

[Dreamer]

edit
1.2a solved the problem THANKS

Thanks for information, please start a new post if you report such important informaion next time.

Closed.