SkyStar2 and drivers 4.2.11

[chrums]

Hello
Why new DD does not work me from the driver 4.2.11, earlier versions yet they worked on older drivers. DD show the signal (level and quality) but there is no painting.

[X05]

Probably need >= v4.3.2 if using direct.
Did you try B2C2 SDK and B2C2 direct?
Is there reason why you can't use v4.4.11?

[chrums]

I use new drivers 4.4.1 every the day, I ask about older 4.2.11 because as they are better for me (blindscaner works on them)just but hard. What to drivers 4.2.11, then I tried B2C2 SDK and B2C2 direct and this alone is there is the signal but there is no vision.

[BxS]

It's a strange problem, even if don't work with B2C2 direct, should work with B2C2 SDK.

Do you have Full Transport enabled?
If yes, for B2C2 direct disable it for driver versions < 4.3.2

I will test it with B2C2 direct & SDK and see if I have the same problem, but it should work.

(I can use driver v4.2.11 without problems, but I use a different device file)

[BxS]

I forgot to say that my system with driver beta version 4.4.1 became very unstable

[chrums]

I thank BxS for the help very much. I started DD on drivers 4.2.11 eventually, it sufficed to make reset after the change of drivers. I thought that new DD does not work with these drivers. Thanks to great.

[BxS]

Yes, I tested B2C2 directly with 4.2.11 and it work nice

[rel]

considering it is ok now