Dear All,
I am using DVBDream 1.4i with Skystar-2 V2.6d PCI Card.
In my location most of the free to air channels are in C-Band.
I can able to tune only Horizontal channels,but not Vertical channels in C-Band
Is there any way to tune Vertical channels in C-Band.
If so how can do it.
Sorry for rmy poor English
DVBDream V1.4i C-Band tuning
Selvam I use C band LNB to receive from many sats. I have no such problem. There is no need to select voltage in DD. It will select automatically.18V = Horizontal 13v = Vertical . With a multimeter you can check if you get 13V.check for any short on your cable. Lastly I had a nearly similar problem. I could receive only verticals on C band. I changed three LNBs with same problem. I discovered that It was one of my Diseqc ports that was causing this problem. Is your problem on c band only? Have you checked if your vertical probe is functioning.
TBS 5922 USB
iMAC late 2012 /windows8 64bit vmware
3M prime motorised from AM33 (96.5 E) to AM44 (11W),
1.5m on Eutelsat 36A/B
2.4m solid with two LNBs on PAS 7/10 C/ku
60 cm on Eutelsat16A
iMAC late 2012 /windows8 64bit vmware
3M prime motorised from AM33 (96.5 E) to AM44 (11W),
1.5m on Eutelsat 36A/B
2.4m solid with two LNBs on PAS 7/10 C/ku
60 cm on Eutelsat16A
Dear patmos,
Thanks for your reply.
I am receiving the H & V channels of C-Band in my HUMAX VACI-5300.So i think that there is no problem in the C-Band LNB. I think the problem may be in Skystar-2(Hardware) voltage switching. Any suggestion regarding checking the problem in Hardware is expected. Sorry for my poor English.
Thanks for your reply.
I am receiving the H & V channels of C-Band in my HUMAX VACI-5300.So i think that there is no problem in the C-Band LNB. I think the problem may be in Skystar-2(Hardware) voltage switching. Any suggestion regarding checking the problem in Hardware is expected. Sorry for my poor English.
Technisat Skystar2 v.2.6d
Dear Members.Dear patmos,
Thanks for your reply.
I am receiving the H & V channels of C-Band in my HUMAX VACI-5300.So i think that there is no problem in the C-Band LNB. I think the problem may be in Skystar-2(Hardware) voltage switching. Any suggestion regarding checking the problem in Hardware is expected. Sorry for my poor English.
Please help me to solve the problem.
Technisat Skystar2 v.2.6d
Who is online
Users browsing this forum: No registered users and 1 guest