Please help with DiseqC raw commands

General discussion . (Do not post bug reports or feature requests in this section!)

Moderators:X05, Dreamer, FredB

Post Reply
andy62
Posts:2
Joined:Tue Jul 22, 2008 9:24 pm
Please help with DiseqC raw commands

Postby andy62 » Tue Jul 22, 2008 9:34 pm

22kHz OFF uncomited disabled
Lnb1 E0 10 38 F0
Lnb2 E0 10 38 F4
Lnb3 E0 10 38 F8
Lnb4 E0 10 38 FC
DiseqC connected to 22kHz swith 22 OFF port
5th sattelite connected to 22kHz switch ON port nad I need help here with commands. Thanks in advance :oops:
Top
jerryt
love DVB Dream!
Posts:153
Joined:Mon Jun 19, 2006 11:15 am

Postby jerryt » Wed Jul 23, 2008 3:45 am

What is your question, you have all the needed information?
Twinhan 1020a driver 2.4.1.1, Skystar2 2.3 driver 4.4.0, Genpix USB, T90 and SG2100 w QPH-031.
Top
andy62
Posts:2
Joined:Tue Jul 22, 2008 9:24 pm

Postby andy62 » Wed Jul 23, 2008 9:20 am

What is your question, you have all the needed information?
Problem is using those raw commands i don`t have any signal ( no problem with DiseqC 1.0/ 2.0 configuration ) . Are those Raw commands correct?
Top
jerryt
love DVB Dream!
Posts:153
Joined:Mon Jun 19, 2006 11:15 am

Postby jerryt » Wed Jul 23, 2008 12:15 pm

Those commands are correct.

For "Raw Commands" you select in diseqc switch "None", then under raw diseqc enter the commands you have.

Most likely you didn't select "none".
Twinhan 1020a driver 2.4.1.1, Skystar2 2.3 driver 4.4.0, Genpix USB, T90 and SG2100 w QPH-031.
Top
Post Reply

Return to “General”

Who is online

Users browsing this forum: No registered users and 1 guest