Scan - disable LCN by default

[Dreamer]

I have my own channel numbers for the Remote tab, but every time I scan for changes, LCN is enabled by default and the new channels with their own channel numbers are mixed with my channels, I have to remove the channel number for each channel manually. When I disable LCN, it's OK, but next time it's enabled again, I need to be careful every time, even if I scan just few TPs.

Could you disable this option by default, please, or at least remember the state, so if I disable LCN once, it will be disabled next time, also after DD exit/reinstall...

Thanks.

[rel]

done in upcoming version

[Dreamer]

LCN option is greyed out in 3.2, so I can't disable or enable it. It looks enabled.

[Dreamer]

In 3.2.1 LCN option is disabled now (for me it's OK), but it's still greyed out, so it's impossible to change state of this option.

[Dreamer]

In 3.3 LCN option is disabled by default and it can be enabled manually, the state is not saved, for me it's OK, thanks, Rel.

Topic closed.