Not detecting channels

[aammango]

New to DD, just installed it and set the diseq ports, I don't see the Advanced Scan button like in the tutorial, checked network scan, when I select 61.5 Sat from the drop down it does list all the TPs and when I scan it shows the signal and quality on the meter but does not detect any channels. Please help, I have been using MT and Ritz and I read good stuff about this progy. Thanks.

Aam
Viewsat Xtreme
Vision Plus PCI
Super Dish - 121/119/110
Dish 500 - 61.5
DPP44 Switch - 61.5/1; 119/2; 110/3; 121/4
P4 2.6 Ghz, 1GB RAM; XP SP2

[rel]

most likely Diseqc settings is the problem,

In Options->Diseqc settings, you should probably use "NA Bandstacked DP Ku-Hi (DBS)" as LNB Type , and leave other settings as is.

If you still cant get channels this way, then:

you might also need to test with other drivers, FAQ 20 for Twinhan:
http://www.dvbdream.org/forum/viewtopic.php?t=12

[aammango]

Thank you that did it. What should I use for the 121 its a linear lnb?