why double channels

[Nrmf]

why when i do a scan do i get alot of channels with doulble listings and seems some show as 110 and 119 for the same channel what have i done wrong

[Safename0]

Look like a switch problem configuration.

You scan for 110 and 119. Il the switch did not work for your channel B, it will see channels for your channel A (again). That why it shows channel twice. Check how you config your DIESqC section or verify DISEqC string send.

Good luck !

Safename0

[Nrmf]

ok will check disqec in morning this is new setup in bedroom thought i hooked disqec up the same as i did in living room but i guess not

[Nrmf]

tried switch the sats on the setup of disqec and i still get tons of double channels and the only ones that seem to come in are on 110 so switched it back and rescanning now to see what i get

[DawgE]

What DVB-S card are you using? I had the same issue in the past but we need a little more information as to what you are using to get the signal.

[rel]

What DVB-S card are you using? I had the same issue in the past but we need a little more information as to what you are using to get the signal.

and he could write that information to his signature. so nobody would have to ask same thing again and again.

[Nrmf]

ok will try to figure out this signature thing

[Safename0]

Nrmf,

Did you try another application software (ProgDVB,MT) to verify that your switch is not defective ?

Does it do the same problem with older version of DD (example: DD 0.8.9b) or DD 1.1a.

It seems that your are trying to beam on 110 and 119 for D#SH Network. Am I right ?

Safename0

[Nrmf]

seems i am an idiot if i change the disqec setting under 22khz to off then rescan all seems well double channels go away i had left it at default on this new system in bedroom where it was controlled, now all seems better.. i think i have a signature now so rel keep pumping out the updates...thanks

[rel]

heh, you have a 22 khz tone switch probably (might be built-in on LNBs) or it is somehow interfering the diseqc switch/LNBs when it is "controlled by LNB". glad to hear you fixed it

[Nrmf]

well i know i dont have a switch maybe i didnt write the right option under disqec for you but if i understand you correctly is it possible to use the dual lnbs that have a built in sw21 and just turn it off, if thats the case look out 82 and 91 here i come

[rel]

is it possible to use the dual lnbs that have a built in sw21 and just turn it off, if thats the case look out 82 and 91 here i come

You must ask it to experienced NA users. i'm not very familiar with NA switch and LNB systems. my knowledge about them is just what I have heard/read so far.

DD supports following switching systems:

- 22khz on/of
- Tone burst on/off (Mini Diseqc)
- Diseqc 1.2 (this is only switch type used in Europe)