VisionPlus/Twinhan 1020a + DP Twin Plus = No channels

[jman11]

Per the subject line, I am unable to find any channels when I scan. With a single DP LNB pointed to 119, I received 200+ channels. Also, with my current setup (DP Twin Plus), I hooked up a 301 receiver and confirmed that 119 was coming in strong on all transponders, although 110 was not appearing (could be an issue with the 301).

I am using BDA (not WDM driver) 1.2.2.8, I believe, which is the newest from the Twinhan site. Maybe I need to switch to WDM or use Raw Diseqc?

My diseqc settings for 119 and 110:
Port 1 = 119
Port 2 = 110
Port 3 & 4 = blank (do I need to set something for Port 3 with the DP Twin Plus given that it has a third port for an external lnb even though I have nothing hooked to it currently?)
Switch type = v1 or v2
LNB type = NA Bandstacked Dishpro KuHi (DBS)
LOF1 = 11250000
LOF2 = 11250000
Raw Diseqc = blank
22 Khz = off
Uncommited = disabled

Thanks,

JR

[jman11]

Being the idiot that I am, I forgot that the twinhan can't power a DP Twin Plus by itself. I hooked up my receiver to the other outbound port on the lnb, and I am getting channels on 119 (haven't tested 110).

I also put in raw diseqc as mentioned in a different post, but I don't know if those made a difference (http://www.dvbdream.org/forum/viewtopic ... =twin+plus). I will try without the raw diseqc and report back.

[jman11]

Raw diseqc settings don't seem to make a difference.

However, while I can scan channels very well on 119, when I try to watch anything (NASA, for example) nothing happens - signal = 0.

Also, I can't get anything on 110 - it looks like it picks up some channels from 119. However, I think this is a dish aiming issue (I for some reason have a terrible time getting 110 and have tried to DP Twin lnbs with no success). I've set it to the correct elevation and skew, made sure the mast is perfectly level, and covered the 110 port with aluminum foil to make sure I was picking up 119 on the correct port.

Any thoughts?