Anyone using 22khz switches?

[dave99]

I cant seem to get a signal on the lnb's that are connected to the 22khz side of the 0/22khz switch, the 0khz lnb's work fine but not the 22khz ones.
My viewsat receivers pick everything up so i know every lnb is working, but my skywalker+dvbdream cant pick up the 22khz ones even though they are set to 22khz in dvbdream.
Is it the skywalkers thats at fault or dvbdream?

[genpix]

and how is your LNB (for ON-side of 22Khz switch) configured?

[dave99]

Other than the on/off selection everything is the same... i take it this is the problem?

[genpix]

Other than the on/off selection everything is the same..

Then it should work.
check other settings then.

[dave99]

What other settings can i check?
Btw have you gotten it to work with 22khz switches?

[jerryt]

It works for me, but I use the "SW" setting of 11700 and 13700 instead of "on" "off".

[genpix]

What other settings can i check?

The ones you are notoriously omitting from your description.

The answer is always as good as the question.
If you provide NO details in the question, you'll get NO details in the answer.

[mrnewbie]

It works for me, but I use the "SW" setting of 11700 and 13700 instead of "on" "off".

Jerryt.....I learned something today...From the above..I assume I can use the software option to switch on/off..on the 22mhz switch...i didn't know that thanks for that little piece of info...


also may I ask...I'm having problems with my Invacom031... On the linear lnb side...i'm not sure which lnb type to select from the DVB dream pulldown...since you are woking with an invacom 031...which LNB type are U using?

Here are the options that are listed in a pull down menu with DVB dream..

KuLinear(universal)
KuCircular
Backstacked Dishpro Ku-HI(DBS)
Backstacked Dishpro Ku-Lo(FSS)
Backstacked Ku-HI(DBS)
Backstacked Ku-Lo(FSS)
Backstacked C
Legacy
Other