No channels found

[Moemar]

I just bought a Skywalker-1 and decided to give DvbDream a shot. I set up the diseqc settings as closely to my Viewsat settings as possible. When I went to scan for channels, I get "no channels found" most of the time, with a few "no signal"s mixed in. Signal quality is consistently in the high 90s, so it would seem that something's getting through. Any ideas?



LNBs are set to "NA Bandstacked DishPro KU-Hi (DBS)", 22 kHz off, and uncommitted disabled. Switch is whatever came with the Viewsat. I've tried playing around with the settings, but no luck.

[wadesi79]

I have the exact same setup and exact same problem as you. Someone please help!

Used exact same setup and settings as my Viewsat Ultra.
Sats: 110, 119
DishPro LNB
Diseq Switch Ports 1, 2

Getting Q and L in the 90%'s but getting mixed "No channels!" and "No Signal" during scan.

[wadesi79]

I have the exact same setup and exact same problem as you. Someone please help!

Used exact same setup and settings as my Viewsat Ultra.
Sats: 110, 119
DishPro LNB
Diseq Switch Ports 1, 2

Getting Q and L in the 90%'s but getting mixed "No channels!" and "No Signal" during scan.

[beagle]

Make sure you have diseqc 1.0/2.0 selected and try different settings.

[Dominion]

I'm having this exact same issue. I have tried every setting I can think of. When I scan I get S / Q in the 90-100% range and the TPs with no signal match the TPs on my other box that I get no signal on. But for some reason all I get is "No channels found!"

Anyone have any ideas?
I'm using Skywalker-1 and Dish Pro LNB (has 2 coax out, not DPP)

[rob1971]

i SEE i AM NOT THE ONLY ONE HAVING TROUBLE GETTING THIS UP AND RUNNING.

[athomas]

These are the settings I use for my Skywalker-1. I get all the channels on 110 and 119. I do use generic dual output LNBs and a 4 port switch though, so it may not work the same.

Make sure you set diseqc: 1.0/2.0
LNB type: Ku - circular
Lof - 1: 11250000
22KHz switch: off
Uncommitted switch port: disabled